What Size For Max Ii 6x6 Drain Plug

Introduction

The following procedure is right for all Duratec engines in the Ford Focus, including the 2.3L engine in 2004-2007 models. Equally stated on the oil filler cap, use 5W-twenty oil when calculation or changing oil. In that location are a number of different oil filters past unlike manufacturers that will piece of work for the Focus, so yous may desire to consult the parts counter at your local auto parts shop.

Convention has e'er been to alter oil at 3,000 mile intervals, merely mod oil and oil filters let for much more fourth dimension betwixt changes. As long as yous check your oil level regularly, you can easily make information technology 5,000 miles with conventional oil, and over 7,500 miles with constructed oil.

Use ramps or jack stands to raise the front of the car and chock the rear wheels to keep the car from moving.

Utilize ramps or jack stands to raise the front of the car and chock the rear wheels to continue the car from moving.
Remove the oil filler cap past rotating information technology 1/4 turn counterclockwise and lifting it off the valve cover.

Locate the oil pan drain plug underneath the car. It is a 13 mm hex bolt that faces towards the rear of the car.

Locate the oil pan drain plug underneath the car. It is a 13 mm hex bolt that faces towards the rear of the automobile.
Identify an oil bleed pan underneath the oil pan to grab the draining oil. Remember to place information technology towards the rear of the automobile, since the oil volition come up out of the oil pan in a stream.
Exist very cautious when working nether a motorcar that has been running recently, because the oil pan and transmission will exist very hot.
Loosen the oil pan drain plug with a 13 mm socket wrench until information technology comes off and oil is draining out of the oil pan.
Lookout man for shiny specks in the draining oil. Small metal flakes could hateful a serious trouble inside your engine.

This step is only necessary if you wish to flush all of the old oil from your engine. You may consider doing this if it has been an especially long time since your terminal oil change or if some foreign liquid has been poured into the filler hole.
Place a funnel in the oil fill hole in the valve embrace.
Pour a quart of oil into the funnel and let all of it bleed and collect in the oil drain pan.
Since very footling of this oil will remain in your engine, yous may want to use the least expensive oil you can find for this.

Wipe off and replace the oil pan bleed plug. Use a moderate amount of forcefulness, only do not over-tighten the bolt.
You tin can ever tighten the bolt more if you lot notice oil leaking from the plug. A cracked oil pan, however, is a much more expensive repair.
Position the oil drain pan underneath the oil filter.

Turn the oil filter counterclockwise (when looking up at it) to remove it.
If your filter is on too tight to loosen by hand, you may need to use an oil filter wrench or chugalug wrench to remove it.
Oil will begin to run down the sides of the oil filter. It is up to your discretion to either allow information technology drain slowly this way or take the filter off chop-chop. Keep in mind that no matter what, the filter itself will yet take oil in it that must be drained.
Set the old filter in your oil drain pan with the gasket facing downward to allow the oil to drain out of it.
Once the oil filter is removed carefully inspect the old filter and the filter seating surface on the engine for the gasket from the sometime filter. Sometimes this will remain in place and is a guaranteed major leak if not removed prior to installing the new filter.
Let the balance of the oil from the engine drain and collect in the oil drain pan.

Employ a pocket-size amount of make clean oil to the rubber gasket on the new oil filter.
The use of gloves is highly recommended. If whatever oil gets on your peel, immediately wash your hands thoroughly.
Wipe off the oil filter mounting spot and install the new filter by rotating it clockwise until you cannot tighten it anymore.

Cascade v quarts of 5W-twenty oil into a funnel in the oil fill hole.
Reinstall the oil filler cap by turning it 1/4 turn clockwise.
Start your car and let information technology run. Check for leaking oil underneath the auto. If yous notice whatsoever leaks, tighten the bleed plug, being careful not to over-tighten it and crack the oil pan.
Close the hood and lower the machine back to the basis: you lot're done!

Allow 12-24 hours for all of the oil to drain out of the old oil filter.
Take your old oil and filter to a recycling facility. Most auto parts stores and repair shops have these at no accuse to you lot. In improver, some cities and/or counties accept a service where they will collect used oil and filters from your home. For more information, run across the American Petroleum Institute's web page on used motor oil collection and recycling.
Practice not just throw used oil in the garbage. It is a hazardous waste matter product that needs to be properly disposed.

Embed this guide

Choose a size and copy the code beneath to embed this guide as a small-scale widget on your site / forum.

Preview